How do I get my cisco router out of ROMmon mode?

Table of Contents

If your router gets stuck in ROMmon mode during the boot process, examine the value of the configuration register by entering the confreg command. Change the value of the configuration register as shown below to stop the router to go into the ROMmon mode after reloading.

How do I reset a Cisco switch to ROMmon mode?

Use the option config to reset the start-up configurations. Use the option boot-vars to reset the user added boot variables. After the factory reset process is successfully completed, the device reboots and stops at ROMMON mode.

How do I reset my Cisco 2960 to factory settings?

Reset a Cisco 2960 Switch to Factory Default Settings

– Start by connecting your cisco switch via a console cable that will be also connected to the same console.
Step 2.- Use the following commands: Router: en. Router#erase startup-config. Router# del flash:vlan.dat.
– Reload your cisco switch to complete the restoration.

How do I boot a Cisco router from USB in ROMmon mode?

While the router is powered off, plug in the USB flash drive to the USB port on the router. Power on the router and when it starts to boot up press the Break key to enter ROMMON mode.

Why does the catalyst 6500/6000 switch go into RP ROMMON?

If the Catalyst 6500/6000 runs the Cisco IOS image and the boot loader image is either corrupted or missing from the MSFC1 (RP), the switch goes into either RP ROMmon or SP ROMmon at the next reload. This depends on the environment variable settings on the Catalyst 6500/6000. Find out which ROMmon the switch is in.

What is the Cisco Catalyst 6500 supervisor engine 720 image?

s72033-jk9s-mz.122-14.SX is the Catalyst 6500 Supervisor Engine 720 Cisco IOS Software Release 12.2 (14)SX image (with Supervisor Engine 720/MSFC3/PFC3a). You cannot boot the switch when you encounter any of these situations:

Can I run Cisco IOS software on the catalyst 6500/6000?

In order to run Cisco IOS Software on the Catalyst 6500/6000, you need to have both images installed. Note: MSFC2 does not require a boot loader image (c6msfc*-boot) in the MSFC2 boot Flash device in order to boot successfully when you run Cisco IOS Software.

What is the uptime of the Cisco 2500 router?

RELEASE SOFTWARE (fc1) Router uptime is 7 minutes System returned to ROM by reload System image file is “flash:c2500-js-l_121-5.bin” cisco 2500 (68030) processor (revision D) with 16384K/2048K bytes of memory. Processor board ID 03867477, with hardware revision 00000000 Bridging software. X.25 software, Version 3.0.0.