How do I reset my Whirlpool Ultimate Care II washer?

Table of Contents

How Do I Reset My Whirlpool Washing Machine?

Turn off the washer.
Turn the mode dial to NORMAL.
Turn the dial counter-clockwise one click left, clockwise three clicks, counterclockwise one click, and then clockwise one click.

Why is my washing machine on but not starting?

First, make sure the power is on and that the machine is plugged in. You should check the outlet to make sure it’s working. Then, check if a fuse is blown or a circuit breaker thrown. If those both work, see if the Delay Start button or Control Lock feature has been activated.

How do I reset my Whirlpool washer that won’t turn on?

Follow these steps to reset your Whirlpool washer:

Turn the washing machine off using the control panel.
Unplug the washing machine.
Wait three minutes.
Plug the washer back in, and wait thirty seconds before turning the washer on.

Why did my washer stop working?

Some of the most common faults that will make your washer stop mid cycle include thermostat failure, problems filling up with water for the rinse cycle, or even pump problems that prevent your washer from draining. One thing that you can check yourself is the lid switch.

What is the capacity of a whirlpool Ultimate Care II?

Whirlpool GST9679PW 27 Inch Top-Load Washer with 3.2 Cu. Ft. Capacity, 27 Automatic Cycles & Ultimate Care II Wash System: White w/ Silver Metallic Console For the best AJ Madison experience, JavaScript needs to be enabled in your browser.

How to repair Whirlpool washer?

Move the washer two feet away from the wall and remove the 10-1/4-in. screws securing the back panel to the washer.

Remove the back panel. The coin trap cover,pointing toward the side of the washer,will be visible under the tub.

Access the drain coin trap and follow the procedure above to get the water out.

How to troubleshoot Whirlpool Cabrio dryers?

Disconnect the power cord from the wall.

Turn off the water supply and disconnect water inlet hoses from the rear of the machine.

Pull the washer away from the wall to allow you room to work.

Loosen the screws on the access panel so you can remove it.

Locate the drive motor and belt.

Use an adjustable wrench to secure the motor’s mounting nut.

Why is my Whirlpool Cabrio washer not draining?

Why is my Cabrio washer not draining? Check the washer’s discharge hose if the water fails to drain from the washtub. Look for any kinks in the Cabrio washer’s discharge hose that could stop the water from draining. Straightening the hose ensures proper draining. Test the drain pump to ensure it has not failed if the washer still will not drain.