How do you clear a Trane thermostat error?

Table of Contents

How to reset trane thermostat after power outage

Turn the thermostat to the “Off” position. Wait a few minutes, then turn the thermostat either to “Heat” or “Cool.”
Set the thermostat to the desired temperature.
Go to the circuit breaker box if you do not feel or hear airflow.
Turn the thermostat off and then on again.

What does Trane Error 89 mean?

Trane thermostat error code 89 Meaning: the stat can’t “find” the cooling/heating equipment. Action: Check for a tripped breaker/blown fuse (to your outdoor unit)- these two are common culprits for error 89. But it can be a wiring problem somewhere in the system so check the wiring too.

What could cause a 3 Flash error code?

What it means: Have you ever looked at your furnace and thought what do 3 flashes on American Standard furnace mean? This error occurs when the combustion air pressure switch that monitors the flow of air through the vent system fails to close while the induced draft motor is operating.

How do you reset a Trane thermostat after a power outage?

How to Reset a Trane HVAC After a Power Loss

Turn the thermostat to the “Off” position. Wait a few minutes, then turn the thermostat either to “Heat” or “Cool.”
Set the thermostat to the desired temperature.
Go to the circuit breaker box if you do not feel or hear airflow.
Turn the thermostat off and then on again.

Where is the reset button on American Standard furnace?

Locate the reset button on the furnace and press it to reset the furnace. It is usually located inside the blower compartment on the side of the blower motor. Be cautious as the housing may be hot. If the button is popped up, press it down.

Is there a troubleshooting guide for American Standard Thermostat problems?

In most cases, you can solve the American Standard thermostat problems without calling in a technician as long as you know what to do. In this troubleshooting guide, we are going to cover the most common errors, their error codes or symptoms, why they occur and tell you how to address them.

What are the out of Range faults on my thermostat?

Ambient Temperature Sensor Fault (Out of Range – Open or Shorted) ERR 67 6 Flash Coil Temperature Sensor Fault (Out of Range – Open or Shorted) Low Pressure Cut Out Fault (Open outside of defrost Cycle-Hard lock out, cycle power to reset) ERR 79 7 Flash 79 Low Pressure Cut Out Fault Heat/Cool Lock out

What are the ERR codes for the defrost temperature sensor?

ERR 91 Loss of Bit Master (Clock Signal) 2 Flash Defrost Fault A 3 Flash 68 Defrost Fault B and/or C N/A 4 Flash Defrost Fault A and [B and/or C] 5 Flash 67 Ambient Temperature Sensor Fault (Out of Range – Open or Shorted) ERR 67 6 Flash Coil Temperature Sensor Fault (Out of Range – Open or Shorted)

What should I do if my thermostat does not turn on?

Set Mode to cool and lower the setpoint below room temperature. 2. If cooling does not come on within 15 minutes, contact servicer. 3. Repair connections. 4. Repair system / Replace control.