How do you reset the salt level on a Hayward Aqua Plus?

Table of Contents

With the pump running, take the power switch down to the “Off” position, and then back up to “Auto”. You should hear a click within 10 or 15 seconds. When you do, press the diagnostic button five times in a row. The system will go through a recalibration process.

What should my Hayward salt chlorinator be set at?

2700 ppm to 3400 ppm
Salt Systems work best with approximately 3200 parts per million (ppm) of salt, which is roughly the equivalent to a teaspoon of salt per gallon. However, all Hayward Salt Systems are designed to operate with salt levels anywhere from 2700 ppm to 3400 ppm.

How do I reset my Hayward salt system?

Reset AquaRite Salt Chlorination Inspect Cell Light If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.

How do you unlock the configuration menu on Hayward Aqua Plus?

Press the ‘Menu’ until, ‘Configuration Menu-Locked’ appears. To unlock, press and hold the (<) & (>) until the text, on the display, changes from ‘Locked’ to ‘Unlocked’ (unit will beep). Press the (>) repeatedly, until ‘Chemistry Config. Wizard’ appears on the display.

How do I reset my Hayward salt cell after cleaning?

How often should I super chlorinate my saltwater pool?

weekly
Always Superchlorinate with the filter on, and do so weekly during the swimming season to clear a pool of any excessive contaminants. You should always do it with the filter pump turned on, not off.

Why is my salt chlorinator not working?

The saltwater chlorinator needs a sufficient flow of water for effective operation. A dirty skimmer basket, clogged or dirty filter, and a clogged pump strainer, can cause insufficient water flow for the chlorinator to produce less chlorine.

Do I need to use salt with Aqua plus control?

Salt is required only if you are using the chlorinator features on the Aqua Plus Control. If you are NOT using the chlorinator, it is recommended that you follow all of the other chemistry recommendations be- sides salt.

Where can I find the Aqua plus operation manual for Aqua plus?

G LINE ONTROLS www.goldlinecontrols.com 888-921-7665 Aqua Plus Automation and Chlorination Operation Manual for model AQL-PLUS AQL-PLUS-20 (actuators, cell & remote display not included – order separately) LD C G LINE

How do I Turn my Aqua plus into a spa-only operation?

Pressing the POOL/SPA button will switch the Aqua Plus to spa-only operation (right LED illuminated). Pressing the POOL/SPA button again will switch to spa spillover operation (both LED’s illuminated). Pressing the POOL/SPA button again will switch back to pool-only. Note that the filter pump will turn off while the pool/spa valves are turning.

What happens if the salt level is too low in aqua plus?

•Low Salt/Minerals or Very Low Salt/Minerals — when the salt is too low the Aqua Plus will generate less chlorine and the life of the cell is degraded. Check the cell and clean if necessary (see instructions, page 29) before adding salt (see instructions, page 26).