Is Lexan cheaper than Plexiglass?

Table of Contents

When it comes to cost, Plexiglass is usually cheaper than other materials, including Lexan.

Is there a difference between Lexan and Plexiglass?

Lexan is the strongest and can withstand impacts to such a degree that it won’t crack. Instead, it displays resistance by bending. Plexiglass is still quite strong, but it may crack or chip, given enough time or impact. That’s because it’s a little less rigid than Lexan.

Which is easier to cut Lexan or Plexiglass?

Plexiglass also has a higher UV tolerance than Lexan and, therefore, does not get yellow over the time. While Lexan is easier to cold bend whereas Plexiglass is easier to cut and also has a cleaner, more attractive glue joint than Lexan.

Is Lexan stronger than acrylic?

Sheet grade polycarbonate (aka Lexan or Makrolon) and acrylic sheet (aka Lucite) are two of the most frequently used see-through plastics. Each of the two have benefits and drawbacks. Acrylic is shinier and polycarb is stronger.

Can you bend Lexan?

Lexan Sheet can be cold bent and can bend to tighter curves than polymethyl methacrylate, Acrylic. Bending Lexan sheet is easy because of its excellent flexibility factor.

Can Lexan be cut with a saw?

Lexan can be cut with almost any saw, but problems arise if the wrong blade is used because of heat build-up and Lexan’s low melting point. Use a fine-toothed blade and move slowly to cut Lexan properly.

Can you cut Lexan with scissors?

The scissors make quick work of cutting the Lexan and for the most part are quite self-explanatory as to how they are used. The curve in the scissors helps cutting curved lines easier. They can also be used to trim off jagged edges from Lexan leftover from the scoring process if the score line was not deep enough.

What is the best tool to cut Lexan?

When you need to cut Lexan, you can essentially treat it as a sheet of plywood and cut it with any power saw you would use for that material. Make straight cuts with a circular saw or table saw, and curved ones with a band saw or jigsaw. You should use carbide-tipped blades with closely spaced teeth.