AdministratorWhat tank replaced M46 Patton?
M47
The M47 was the U.S. Army’s and Marine Corps’ primary tank, intended to replace the M26 Pershing and M46 Patton medium tanks….
| M47 Patton | |
|---|---|
| M47 Patton on display | |
| Type | Main battle tank |
| Place of origin | United States |
| Service history |
What tanks did Patton use in ww2?
The vehicles were indeed rented from the Spanish Army, but none were of German origin. The British tanks are portrayed by M24 Chaffee light tanks and the German tanks by M48 Patton tanks, ironically enough. The American tanks are M41 Bulldog Walkers and M47s, the latter also known as the Patton tank.
What replaced the Pershing tank?
The M46 Patton was an American medium tank designed to replace the M26 Pershing and M4 Sherman. It was one of the U.S Army’s principal medium tanks of the early Cold War, with models in service from 1949 until the mid-1950s.
Has any M1 Abrams been destroyed?
A total of 23 M1A1s were damaged or destroyed during the war. Of the nine Abrams tanks destroyed, seven were destroyed by friendly fire and two intentionally destroyed to prevent capture by the Iraqi Army. Some others took minor combat damage, with little effect on their operational readiness.
What will replace the Abrams?
The Abrams was due to be replaced by the Future Combat Systems XM1202 but due to its cancellation, the U.S. military has opted to continue maintaining and operating the M1 series for the foreseeable future by upgrading with improved optics, armor and firepower.
What was the best tank in World War II?
Though later tanks produced during this time period proved to have better armor and armament, the T-34 is often recognized as the most effective, highly influential and efficient tank design of WWII.
What was the best US tank in ww2?
A massive 90mm main gun, good mobility, and excellent range all combined to make the M36 an effective weapon.
Is T47 a solution to a problem?
4. T47 is a solution to a problem that shouldn’t exist Chris Cocalis is the owner of Pivot Cycles and a proponent of well-designed press-fit bearing systems. He points out that press-fit systems can work, so long as component and frame manufacturers actually adhere to a set of tolerances, like they do for headsets.
What does T47 add to weight?
T47 addresses the problem at the frame level rather than the BB component level where it should be addressed in the first place. Last, I’ll call complete BS on your claim that a T47 system will add 1/4 pound or anything remotely close to 100 grams of weight to a bike.
How long does it take for a T-47 to reboot?
When taking a certain amount of damage, a T-47 will shut down and it takes few seconds to reboot . Community content is available under CC-BY-SA unless otherwise noted.
What is a T47 bottom bracket?
It’s these problems with the non-threaded bottom brackets, that has me excited about the relatively new bottom bracket type, called T47 (T for “threaded,” and 47 for their 47mm nominal cup diameter). Finally, we will get back to bottom brackets and cranks that get installed once and run trouble-free.