How much does it cost to rebuild axle?

Table of Contents

Average Differential Repair Cost These are light repair jobs that will cost between $200 to $400, depending on the make and model of your vehicle. But if you have more extensive damage to your differential that requires it to be dismantled or overhauled, then you are looking at about $400 to $800 in repair costs.

How many hours does it take to rebuild a rear end?

A complete rear differential replacement includes replacing the housing, gears, bearings, and seals. The average time it takes a certified mechanic to perform a differential rebuild at a shop is usually three to five hours.

How much does it cost to have a rear end rebuild?

Depending on the make and model of your car, as well as its condition, expect to spend between $1,500 to $4,000. The other factor is if you buy a new rear-diff or a used/rebuilt one. A used or rebuilt one will help you save money, but it won’t have the same warranty as a new one.

How much is it to rebuild a rear end?

How do I know if I have a Dana 70?

The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford. It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a “70” cast in to the housing and is visually similar to the Dana 60.

What does a Dana 80 come in?

ID A Dana 80 Rear Axle in Chevy, Dodge Ram, or Ford Truck IDN-126. Was: Dana 80 Rear Axles have been in production since the 1988 Model Year. They have been used in Chevy/GMC 1992-2002 , Dodge(1994-2002), and Ford (1988-current) trucks vans, and motorhome chassis.

How long does it take to replace rear end?

To just remove and re-install the entire assembly would require roughly 7 to 11 hours depending on exactly what your circumstances are and what is re-usable or will have to also be replaced.

What is the difference between a Dana 70 and Dana 80?

Dana 70HD – Heavy Duty model uses larger Dana 80 carrier and bearings. Dana High Pinion – Parts listed below are not compatible with reverse rotation front axles. Due to the many unusual variations of the Dana 70 axle, the customer must verify their axle configuration prior to ordering.

What is the restocking fee on Dana 70 axles?

A 20% restocking fee applies to all returns. The Dana 70 axle has been around for decades and is commonly found under full-size GM, Dodge, and Ford trucks. The axle is available in both front and rear applications and features a large 10.5″ ring gear.

How many spline axles does a Dana 70 have?

The axle is available in both front and rear applications and features a large 10.5″ ring gear. Standard D70 models have 30 or 35 spline axles, however, the Dana “Super” 70 is the holy grail of the series with massive 37 spline shafts.