What is the life expectancy of a sewage ejector pump?
7 to 10 years
While most sewage ejector pumps are designed to withstand at least 7 to 10 years of use, with some even lasting much longer, occasionally problems do arise long before the pump has reached the end of its life span.
What are sewage ejectors?
A sewage ejector pump is plumbing equipment that removes wastewater from below-grade areas. In most homes, this applies to basements where laundry or bathrooms can be found.
How often should an ejector pump be replaced?
A good sewage ejector pump should last at least 7-10 years. However, with proper installation and routine care, your pump can last 30 years or more. A common reason people need to replace their sewage ejector pumps is due to faulty installation where plumbers cut corners or used the wrong sized pumps.
What causes a sewage ejector pump to fail?
Why do sump pumps fail? The #1 reason is due to a power outage, not because of a problem with the sump pump unit itself. Other events can cut off the supply of electricity too; for example, the sump pump can get unplugged, or lightning can trip GFCI outlets. Even when the power stays on, the pump itself can fail.
How do sewage ejectors work?
When wastewater goes into the holding tank, there is a float device that activates the pump. Once this device is activated, the wastewater will go into the sewer line or septic tank. As the level of wastewater drops, the float will lower. Once this float is lowered down, the sewage ejector pump turns off.
How do I know if I need a sewage ejector pump?
Do You Need a Sewage Ejector Pump? If your home has a laundry or a bathroom where the plumbing is below the level of the communal sewer line it joins to, then yes, you absolutely need a sewage ejector pump or, in some cases, a sewage grinder pump.
How much are ejector pumps?
How Much Does a Sewage Ejector Pump Cost? Expect to pay between $300 and $800 for a sewage ejector pump. You’ll also need to hire a local plumber for installation.
What happens when ejector pump fails?
Since gravity alone can’t remove the waste from the home, what happens if that crucial step – the ejector pump – one day fails? If that occurs, flushed water and waste can build up in the pipes and eventually burst – usually at their lowest point, which for most homes is the basement.
How do you test a sewage ejector pump?
If the pump hasn’t been used for a while, a plumber can test the function of the ejector pump by pouring three to four gallons of water into the empty ejector basin. The pump should operate smoothly and stop when the basin is empty.